Pre Start Inspection and Operation
3.21
Installation of Non-Hydraulically Powered Attachments
Make sure to keep your hands and feet away from the attachment during the unlocking
process. As the attachment becomes free from the machine, it may move.
There are many available attachments that are very easy to install. To install any of the non-
hydraulically powered attachments:
1. Position the attachment on a level surface.
NOTE
: Clean the inside lower edge of the female attachment mounting plate to remove
any debris that might interfere with the attachment installation.
2. Start the machines engine, lower the loader arm and tilt the mounting plate forwards.
NOTE
: Make sure that both of the attachment lock pins (Item 1,
Figure 3–26
) are in the
“unlocked” position. Refer to Attachment Lock Pins earlier in this section.
3. Slowly drive towards the attachment and align the top edge of the male mounting plate
(Item 1,
Figure 3–27
) and the upper lip of the female attachment mounting plate (Item 2,
Figure 3–27
). Slide the upper edge of the male mounting plate into the upper lip of the
female attachment mounting plate.
Figure 3-27 Non-powered Attachment Installation
CAUTION
1
2
