52
1. Unplug the power cord from the machine and wait 5 minutes.
2. Using a 5mm hex wrench, remove the indicated screw from the Shock
(or Cylinder).
3. Disconnect the Shock from the Treadle, and lower the Treadle gently.
The Treadle will fall abruptly if not supported. Keep hands
away from the inside of the Treadles to avoid possible
serious injury.
4. Remove the upper screw that secures the Shock using a 5mm hex
wrench.
5. Using a 5mm hex wrench, attach the new shock to the Upright and then
the Treadles.
Note:
The settings decal on the Shocks must be up, with the arrows fac-
ing to the rear of the machine.
6. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
!
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the
wall outlet and the machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power
cord in a secure location.