Slave Settings
15
XMSR us
er guide
Remote Settings
R
emo
te Se
ttings
14
XMSR us
er guide
Sla
ve Se
ttings
B
ow
ens
.co
.uk
B
ow
ens
.co
.uk
With the exception of the ‘Function’ setting these settings effect only the operation of the
remote and do not change settings on the slave device.
Transmit / Receive Mode
The mode setting determines how the remote will operate. When set to Tx the remote
transmits settings/sync trigger commands to slave devices. In the Rx mode the remote acts
as a slave device enabling it to be used to trigger flash devices, or act as a camera release.
While in the Rx mode the ‘Slave Settings’ are not active.
In Rx mode the remote will not respond to commands until it has been paired with the
remote controlling it. As with the pairing of other slave devices this is a once only process.
The mode of operation can be changed by pressing the key until the ‘Mode’ page is
displayed. The mode is then selected using the keys.
Note: the XMSR network permits the use of up to 8 master devices (remotes in Tx
mode), however to avoid setting conflicts only one of these must have the ‘Remote’
function enabled (see below).
Function
This setting is only active when in Tx mode. The function mode allows you to select the
amount of functionality the remote is to have. It may be set to ‘Remote & Trigger’ thereby
enabling both adjustment of slave settings & sync triggering. ‘Remote Only’ disables sync
triggering & ‘Trigger Only’ disables the adjustment of slave settings.
The function can be changed by pressing the key until the ‘Function’ page is displayed.
The mode is then selected using the keys.
Press &
hold
ENT
Recharge Speed
The Recharge Speed
can be adjusted by
pressing the key
until the Recharge
Speed page is
displayed. The
required option can
then be selected using
the keys.
NOTE: The Recharge Speed function is only compatibe with units that include this
feature. Currently not supported on the XMS.
Sync (Photocell)
The cell sync can be
adjusted by pressing
the key until the
Sync page is
displayed. The required
option can then be
selected by pressing
the keys.
Press &
hold
ENT
Press &
hold
ENT
BWL0850_XMSR_user_guide.indd 16-17
14/11/2016 13:20