Slave Settings
13
XMSR us
er guide
Slave Settings
Sla
ve Se
ttings
12
XMSR us
er guide
Sla
ve Se
ttings
B
ow
ens
.co
.uk
B
ow
ens
.co
.uk
Head On/Off
The flash head can be
switched on or off by
first selecting the
‘Head’ sub-menu
using the key,
then selecting either
‘On’ or ‘Off’ as required
using the keys.
Note: Some slave devices do not support all modelling modes. These devices will
continue to operate in the last valid selected mode.
Modelling Mode
The modelling mode
can be adjusted by
pressing the key
until the modelling
mode page is
displayed. The
required option can
then be selected using
the keys.
Ready Indication
Mode
The flash ready
indication mode can
be adjusted by
pressing the key
until the indication
mode page is
displayed. The required
option can then be
selected using the keys.
Press &
hold
ENT
Press &
hold
ENT
Press &
hold
ENT
Changes to the settings below are actioned only by slaves on the current channel & group.
Settings for each group are stored, and are fully independent of each other. Slave devices
are updated immediately once a setting is changed, however should a slave device be
activated or changed to operate on the masters current group/channel, the remote should
be test fired to synchronise the slave settings with those of the remote.
NOTE: In the event the remote is set to a power level lower than that can be achieved
by one of its slaves, that slave will be set to its minimum power level. In such a case the
displayed values on the remote and slave will differ.
Flash Power
When in the main
menu pressing either
the P+ or P- keys
adjusts the flash
power.
Modelling Lamp
Power
When in the main
menu pressing either
the M+ or M- keys
adjusts the modelling
lamp power.
Modelling Lamp
On/Off
The modelling lamp
may be switched on or
off by first selecting
the ‘Modelling’ sub-
menu using the
key, then selecting
either ‘On’ or ‘Off’ as
required using the
keys.
Press &
hold
ENT
Press &
hold
ENT
Press &
hold
ENT
BWL0850_XMSR_user_guide.indd 14-15
14/11/2016 13:20