IMPORTANT:
Always use
ALKALINE
batteries for optimal performance.
Always remove the batteries for prolonged storage.
CHECK THE BATTERIES
if your detector exhibits any of the following
symptoms:
●
1
The unit does not turn on.
●
2
Low speaker volume.
●
3
Unable to tune detector with the discriminate knob.
The Low Battery indicator light will come on and stay on whenever the
batteries need replacing. It should flash momentarily when the Power
Switch is turned on.
IMPORTANT:
Your Ultra Mag Sharp Shooter metal detector requires two
9-Volt
ALKALINE
batteries.
Follow these steps to install the batteries.
●
1
Carefully remove the
battery compartment door
by pressing the release clip
on the right side of the door.
●
2
Snap one battery onto
each of the terminals and
place the batteries inside
the compartment.
●
3
Replace the compartment
door by carefully inserting
opposite side of clip first.
Then press down on clip side
until battery door snaps into
place.
5
BATTERIES
First Battery
Second Battery
First Battery
terminals facing in
Second Battery
terminals facing out
Release
Clip