6
Use
ALKALINE
batteries only.
To install the
batteries:
●
1
Remove the
battery cover by
disengaging the
clip at the back.
●
2
Align the polarity
of the batteries
correctly, with
the positive "+"
toward the coil
plug connection,
as indicated by
the + and –
indicators on the
housing.
●
3
Insert (2) 9-Volt
ALKALINE
batteries, with the contacts pointed inward,
and press down on the back of the batteries to snap them into place.
Some brands of batteries will require moderate force to clear the
retaining tabs.
If the batteries fit loosely, and you want
to guarantee a very secure electrical
contact, insert a piece of paper or thin
cardboard between the back of the
battery and the supporting post.
●
4
Replace the battery door.
The Low Battery Indicator will come on and stay on if the batteries need
to be replaced.
Most metal detector problems are due to improperly installed batteries,
or the use of non-alkaline or discharged batteries.
If the detector does
not turn on, please check the batteries.
If the detector does not turn on,
check to see that the batteries fit tightly.
If the batteries are loose, press them forward while pressing the POWER
touchpad. To tighten up a loose battery, wedge a piece of paper or thin
cardboard between the back of the battery and the supporting post, as
illustrated above.
BATTERIES
IN CASE OF LOOSE BATTERIES
