2. Rinse Power Cloner parts
Make sure your Cloner is clean and debris free before using.
This can be done by rinsing all components prior to use.
Key items to rinse: Reservoir, Lid, and Manifold.
*Note: Make sure manifold is cleaned thoroughly.
3. Install the Sprayers
a
Gently thread a sprayer into each site on the manifold.
Hand tighten the sprayers.
b
Use the yellow hole punch/wrench to tighten the sprayers
until snug. Make sure arrows are pointed away from reservoir
wall. Do not over-tighten as this can strip the threads.
*Note: Sprayer adjustment may be needed to ensure all sites receive
adequate spray.
2
3a
3b
Run water through the manifold
