ACCESSORY INSTALLATION
INSTRUCTIONS
STEREO
Installation Instructions for the 130, 150 & 170 Super Sport
Issue Date
05/11/2010
Rev: C
PROCEDURE NO.
AI-MS-012
8.2.5. Using the Phillips head bit and
hardware supplied, secure the
stereo unit to the console.
8.3. Install the auxiliary input jack (
130SS only
)
8.3.1. Measure 5/8” out from the radius on the starboard
flat face of the storage pocket located on the
starboard side of the console. Using the pencil
make a vertical mark.
8.3.2. Measure 1 1/4” up from the base of the flat face of
the storage pocket. Using the pencil make a
horizontal mark to intersect the mark made in the
previous step.
8.3.3. Using the drill w/ 11/16” drill bit, drill through the
console at the intersection of the marks made in
steps 8.3.1. & 8.3.2.
8.3.4. Remove the nut from the back of the input jack.
8.3.5. insert the jack wires and jack into the hole made in
step 8.3.3.
8.3.6. Replace the nut and secure the input jack by
tightening the nut from the underside of the console.
Page 5 of 11
