9
OPERATING YOUR N88RH-2MCN 2-IN-1 FRAMING NAILER
EYE PROTECTION which conforms to ANSI specifications and provides
protection against flying particles both from the FRONT and SIDE should
ALWAYS be worn by the operator and others in the work area when loading,
operating or servicing this tool. Eye protection is required to guard against
flying fasteners and debris, which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye
protection equipment must conform to the requirements of the American
National Standards Institute, ANSI Z87.1 and provide both frontal and side
protection. NOTE: Non-side shielded spectacles and face shields alone do
not provide adequate protection.
IMPORTANT - READ CAREFULLY!
You and others working around you can be seriously injured by this tool if you do not follow the
instructions provided on the tool and in the operation manual. Used properly, the tool provides
an easy, safe, and efficient method for driving nails for all kinds of construction projects.
NOTE:
Refer to your Operation Manual or Parts List if any of the terms used below are
unfamiliar to you.
SEQUENTIAL TRIP
Your new Bostitch tool with the Sequential Trip (gray trigger):
1. Offers a positive safety advantage since it will not accidentally drive a nail if the tool is
bumped against any surface or anybody while the operator is holding the tool with the trigger
pulled.
2. Allows Place Nailinq without the possibility of driving a second nail on recoil.
The Sequential Trip (gray trigger) gets its name from the "sequence" required to operate the
tool. To drive a nail, the operator must first depress the trip against the work and then pull the
trigger. To drive a second nail, the operator must lift the tool from the work, release the trigger,
and then repeat the above sequence.
TO AVOID SERIOUS INJURY FROM FASTENERS AND FLYING DEBRIS WHEN
INSTALLING METAL CONNECTORS WITH THE N88RH-2MCN:
• Always use the Metal Connector Attachment. (see installation instructions).
• Only use sequential trip(gray trigger).
• Use only genuine Bostitch metal connector nails.
• Use only one stick of metal connector nails at a time.
• Metal connector nails are not designed to penetrate metal. When installing metal
connectors, always place the Metal Connector Attachment Guide in the metal connector’s pre-
formed hole before attempting to drive a fastener
