22
Note:
Pictures may vary from your machine model
MIG MANUAL SPOOL GUN SETUP CONTINUED
Remove nozzle and tip from torch and
press wire feed button, this will feed the
wire through the torch. Release trigger
when wire appears at the end of the torch.
15
Re install tip and nozzle to torch and trim
wire to the end of the nozzle.
16
To adjust functions, press parameter button,
rotate left knob for function selection and
rotate right knob for adjustment then press
parameter button again for confirmation.
Turn the spool gun selection ON.
18
Function
Setting
1
Trigger
2T or 4T
Selection for 2T and 4T.
2
Burnback
0 ~ 10
Selection for the amount
of wire to ‘burn back’ after
release the torch trigger.
3
Pre-Flow
0.1s ~ 5s
Selection for gas flow time
prior to the arc starting.
4
Post Flow
0.1s ~ 10s Selection for gas flow time
after the arc finishes.
5
Slow Feed
0 ~ 10
Selection for wire feed
speed when welding
6
Spool Gun
ON or OFF
Switch for Spool Gun
Press 2T/4T button to select 2T or 4T mode.
2T Mode.
Press the gun/torch trigger to
weld and release to stop.
4T Mode.
Press
and release the gun/torch trigger to start,
weld without holding the trigger on and stop
by pressing and releasing the trigger again.
17
Press Menu button and adjust knob to select
MIG Manual then press knob to confirm
14
Replace the spool cover and close the wire
drive cover
12
Switch the machine ON using the mains
power switch. Wait a few seconds whilst
the machine powers up.
13
ON
