17
MIG MANUAL SETUP (GAS) CONTINUE
Note:
Pictures may vary from your machine model
Re install tip and nozzle to torch and
trim wire to the end of the nozzle.
11
Press Menu button and adjust knob to select
MIG Manual then press knob to confirm.
9
Press 2T/4T button to select 2T or 4T mode.
2T Mode.
Press the gun/torch trigger to
weld and release to stop.
4T Mode.
Press
and release the gun/torch trigger to start,
weld without holding the trigger on and stop
by pressing and releasing the trigger again.
12
Fit the Earth lead Dinse Plug to the negative
terminal for gas welding and then connect
earth clamp to the work piece ensuring that
the clamp makes good contact with bare metal.
5
Turn on regulator and set gas flow to
between 10-15 L/min depending on your
welding environment.
7
Fit gas regulator to the gas bottle and install
gas hose to the gas inlet on the back panel
of welder.
6
Switch the machine ON using the mains
power switch. Wait a few seconds whilst
the machine powers up.
8
ON
Remove nozzle and tip from torch and press
wire feed button, this will feed the wire
through the torch. Release button when wire
appears at the end of the torch.
10
