16
2T / 4T TRIGGER CONTROL
2T Trigger Control
1. Press the trigger and Hold
2. The set pre-gas flow starts and the arc starts and will upslope to the amperage
selected on the amperage dial.
3. When you want to finish the weld, release the trigger and the amperage will begin to downslope at the rate
you have selected on the downslope dial, If you selected zero the arc will stop as soon as you release the
trigger.
4T Trigger Control
1. Press the trigger and Hold
2. The set preflow gas starts and the arc starts.
3. Release the trigger and the amperage will upslope to the amperage selected on the amperage dial
4. When you want to finish the weld, press and hold the trigger and the amperage will begin to downslope
at the rate you have selected on the downslope dial, amperage will remain at this level until you release
the trigger.
5. Once you have released the trigger the arc will stop and the postflow gas will continue for a pre set
amount of time
LIFT ARC START
With a small movement rotate the Gas Cup
forward so that the Tungsten Electrode
touches the work piece.
Press the button on the TIG torch
Now rotate the Gas Cup in the reverse
direction to lift the Tungsten electrode from the
work piece to create the arc.
3
2
4
Lay the outside edge of the Gas Cup on the
work piece with the Tungsten Electrode
1- 2mm from the work piece.
1