www.bosspac.com
4
Installation
When setting up measurement points on equipment it is important to take into account
bearings, bearing support housing, and other structural parts that will respond to the
vibrational forces the equipment will be subjected to.
To best monitor vibrational behaviour at each measuring point, it is necessary to take
measurements in 3 perpendicular directions (X,Y,Z axis). Figures 1 to 3 below show
suggested measurement points for 3 types of machinery. The WASP
TM
measures 3-
axis by default.
Detailed recommendations for specific machine types are provided in ISO document
10816.
The sensor pucks can be attached to the desired equipment by either magnet, epoxy
or stud mount. When using the magnet mount place a small dollop of thermal paste on
the center of the magnet prior to mounting.
The WASP
TM
has an effective range of up to 60 meters from the antenna.
Note: To ensure effective wireless transmission between the sensor pucks
and the antenna it is recommended that there is a direct line of sight between
the units.
Summary of Contents for WASP
Page 5: ...www bosspac com 5 ...
