Boss TGS 1100, Installation & Owner'S Manual

Page: 16 / 27

RT3 Attachment Mounting Procedure
16
Figure 9. RT3 Attachment Mounting Procedure G10390
8. Assemble Driver Side Stabilizer Arm (3)
using four 3/8”
-
16 X 1” Hex Head Bolts
(8) and four 3/8”
-16 Nylon Lock Nuts
(10). Repeat for Passenger Side
Stabilizer Arm (4).
9. Attach Ratchet Strap (5) to outside of the
upper hole of spreader frame using the
“D” ring end of Ratchet Strap (5). Secure
using one ½”
-13 X 1-
½” Hex Head Bolt
(9), one ½”
-13 Nylon Lock Nut (11), and
one ½” Fender Was
her (12). Repeat on
opposite side of spreader.
Note: The previous two steps are only
required for new installations. Stabilizer
Arms and Ratchet Straps will remain bolted
to the spreader.
10. Tighten both Driver Side and Passenger
Side Stabilizer Arms by rotating pad until
tight. Tighten the Jam Nut to secure.
11. Slide the hook end of Ratchet Strap (5)
between the bumper and tailgate of the
truck. Secure to a solid point on the truck
frame rail (this may require drilling a hole
for attachment on the truck frame).
Repeat for second Ratchet Strap (5).
12. Plug Spreader Side Harness into Vehicle
Side Harness.
Figure 10. Stabilizer Arm Adjustment G10392