bag. Continue to move and shake the bag until it
is empty.
Note:
Use 2 people to lift any bagged salt
weighing more than 18 kg (40 lb).
Note:
Keep hands and fingers clear of the bag
splitter when loading materials.
•
If using dry bulk salt, load the salt into the hopper
through the top screen to break up any large,
impassable chunks of salt that may clog the
spreader.
Operating the Spreader
DANGER
Hands, feet, and clothing can get caught in the
moving parts of the spreader and cause serious
bodily injury and loss of limbs.
Keep your hands, feet, and clothing away from the
moving spinner and attachment points.
CAUTION
The spreader throws material at a high speed that
could cause minor injuries to bystanders.
Bystanders should stay a minimum of 7.6 m (25 ft)
away from operating spreaders.
1.
Flip the O
N
/O
FF SWITCH
to the O
N
position.
Note:
Always check for bystanders before starting the
spreader.
2.
Use the speed dial to set your desired spinner speed.
Note:
The spinner speed will determine how quickly
the material is spread as well as how far it is thrown.
3.
While spreading, you can press the B
LAST
switch to
momentarily increase the speed of the spinner motor.
4.
Flip the O
N
/O
FF SWITCH
to the O
FF
position when
you are finished spreading to stop the spreader.
Freeing a Clog
The red LED on the spreader controller will illuminate when
debris gets wedged in the spreader and the controller is
overloaded.
1.
If the red LED illuminates, quickly pulse the B
LAST
button.
2.
If the clog is not cleared automatically, disconnect the
spreader wire harness and manually free the clog.
Adjusting the Material
Deflectors
You can adjust the material deflectors by inserting the
deflector pins into the staggered holes near the spinner
(
).
1
G031018
Figure 24
1.
Material deflector pins
You can adjust the spread pattern by positioning the
deflectors as shown in
.
Figure 25
Deflection Settings
1.
Driver side open
3.
Both sides open
2.
Passenger side open
15
Summary of Contents for TGS 1100
Page 18: ...Notes ...
