Boss Snowplow TGS 1100, Owner'S Manual

Page: 13 / 20

Removing the Spreader
Equipped with the RT3 Attachment
1. Ensure that the spreader controller is in the O
FF
position.
2. Unplug the spreader wire harness from the vehicle wire
harness and attach the weather caps to each end.
3. Pivot the leg-assembly wheels from under the spreader
(
Figure 18 ).
G031258
1
Figure 18
1. Leg-assembly wheels
4. Loosen the ratchet straps and stabilizer arms.
5. Rotate the locking lever on the RT3 attachment to the
U
NLOCK
position ( Figure 19 ).
G031021
1
Figure 19
1. Locking lever
6. Tilt the spreader down to release the top pin of the
RT3 attachment (
Figure 20 ).
1 2
G031020
3
Figure 20
1. RT3 hitch hook 3. Step here
2. Bottom pin
7. Grip the spreader firmly and step on the leg assembly
to rotate it back until the bottom pin of the RT3
attachment clears the hook on the RT3 hitch (
Figure
20 ).
DANGER
The spreader is heavy and could cause serious
injury if dropped.
Ensure that your footing is stable, and avoid
lifting the spreader on slippery or uneven
surfaces.
8. Pull the spreader back and lower it to the ground.
9. Move the spreader to your storage area.
Mounting the Spreader
Equipped with the RT3 Attachment
1. Ensure that the spreader controller is in the O
FF
position.
2. Rotate the locking lever on the RT3 attachment to the
L
OCK
position ( Figure 21 ).
13