g032920
Figure 9
1.
39 cm (15-1/2 inch) hose
3.
Rear fitting
2.
Upper lift-cylinder fitting
8.
Using thread compound, install one end of the
39 cm (15-1/2 inch) hose to the upper fitting on
the lift cylinder (
). Turn the fitting until it
is finger tight, then turn it 2 to 3 more times.
Important:
Do not overtighten.
9.
Creating an “S” shape with the hose, connect
the free end of the hose to the rear fitting on the
hydraulic manifold (
). Turn the fitting
until it is finger tight, then turn it 2 to 3 more
times.
Important:
Do not overtighten.
Installing the Light Bar
1.
Secure the light bar to the top of the coupler
tower through the rear holes using 4 bolts (3/8
x 1-1/4 inch) and self-locking nuts (3/8 inch)
(
). Torque the bolts to 31 N∙m (23 ft-lb).
Note:
If the light bar or plow headlights comes
in contact with the hood of your vehicle, install
the bar using the front holes.
g032921
Figure 10
1.
Light bar
3.
Coupler tower
2.
Self-locking nuts (3/8 inch)
4.
Bolts (3/8 x 1-1/4 inch)
2.
Ensure that the end caps are installed on the
ends of the light bar (
).
g282110
Figure 11
1.
Light bar
6.
Bolt (1/4 inch)
2.
Nylon locknut (3/8 inch)
7.
Headlight bracket
3.
Flat washer (3/8 inch)
8.
End cap
4.
Flat washer (1/4 inch)
9.
Flange-head bolt (3/8 x 1
inch)
5.
Split lock washer
3.
Secure the left headlight-bracket to the light bar
using a flange-head bolt (3/8 x 1 inch), a flat
washer, and a nylon locknut (
Important:
Do not use thread locking
compound on these bolts.
Note:
Do not tighten the fasteners at this time.
8
