5.
Push the SmartHitch2 switch on the side of the
coupler tower upward and raise the tower until
the coupler spring pins snap in (
g032912
Figure 28
1.
Kickstand
3.
Coupler tower
2.
SmartHitch2 switch
4.
Coupler spring pin
6.
Ensure that both coupler spring pins have fully
engaged the coupler (
).
Note:
Move the coupler tower until the spring
pins engage completely.
7.
Pull the kickstand spring pin outward and raise
the kickstand, then release the spring pin to
secure it (
8.
Switch the headlight toggle switch to the P
LOW
position.
Adjusting the Pushbeam
Height
Optional
1.
Measure the distance from the ground to the
coupler spring-pin holes on the undercarriage
pushbeam (
). The measurement
should match the height listed for your plow in
Specifications (page 19)
.
2.
If the pushbeam is not at the correct height,
remove the fasteners securing the pushbeam to
the undercarriage (
3.
Move the pushbeam up or down and secure it
with the previously removed hardware.
4.
Torque the fasteners to 76 N∙m (56 ft-lb).
g230889
Figure 29
1.
Measure this distance.
2.
Fastener
Aiming the Headlights
Important:
Certify that the installation of the
snowplow lights conforms to applicable federal
motor vehicle safety standards.
1.
Park the vehicle on a level surface 7.5 m (25 ft)
away from a matte white screen or garage door.
Note:
The screen should be perpendicular to
both the ground and the front of the vehicle.
2.
Ensure that the vehicle is equipped for normal
operation with the snowplow attached and in the
raised position.
3.
Perform the following actions to ensure optimal
headlight alignment:
•
Remove any ice or mud from under the
fenders.
•
Ensure that all tires are fully and evenly
inflated.
•
Check vehicle springs for sag or broken
leaves.
•
Check the function of any level ride controls.
•
Stabilize the suspension by rocking the
vehicle sideways.
•
Ensure that there is no load in the vehicle
other than the driver.
•
Clean the headlights and matte white screen.
4.
Mark the vertical vehicle centerline on the
screen (
).
16
