21
309003
7.8 Belt Tensioning Procedure
I.
Be sure unit is off and key is removed.
II. Use 3/4” socket to turn the compressor slide plate adjustment bolt clockwise to tighten the
compressor belts.
III. Proper belt tensioning is 1/4” deflection @ 3.3 to 5 lb of force per belt.
7.9 Belt Replacement Procedure
I.
Be sure unit is off and key is removed.
II. Use 3/4” socket to turn the compressor slide plate adjustment bolt counter-clockwise to loosen the
compressor belts. Only loosen enough to remove belts.
III. Remove the old belts.
IV. Install new belts.
V. Use 3/4” socket to turn the compressor slide plate adjustment bolt clockwise to tighten the
compressor belts.
VI.Proper belt tensioning is 1/4” deflection @ 3.3 to 5 lb of force per belt.
VII. Use a belt tensiometer to properly tension the belts.
Maintenance
Over-tensioning belts will cause premature belt, bearing, and shaft seal
failure.
Over-tensioning belts will cause premature belt, bearing, and shaft seal
failure.
Summary of Contents for Bullet 2
