- 4 -
Mounting
See the section “Installation Precautions” on page 2.
Before you drill or cut any holes, investigate your car’s layout very carefully. Take special care when
you work near the fuel tank, fuel lines, hydraulic lines and electrical wiring.
Mount the capacitor in the location away from moisture, and where connection cables are not
pinched or damaged by sharp objects.
1.
Find a suitable location in the vehicle to mount the capacitor.
2.
Secure the capacitor with four supplied screws as follows:
a.
Use the four screw holes on the capacitor to mark the mounting holes on the mounting surface.
b.
Drill the mounting holes on the mounting surface.
c.
Place the capacitor in position, and attach the capacitor to the mounting surface using four screws.
Important note about charging the capacitor
This capacitor must be charged
before
connecting the power cable to the
POSITIVE (+)
terminal on the capacitor.
Failure to charge the capacitor will result in a large spark generated from the rapid inflow of current which can
be very dangerous.
To charge the capacitor, see the section “ Charging the capacitor” on page 7.