27
UNIT INSTALLATION
1. Dashboard
2. Nut (5mm)
3. Spring Washer
4. Screw (5 x 25mm)
5. Screw
6. Strap
Be sure to use the strap to
secure the back of the unit in
place. The strap can be bent by
hand to the desired angle.
7. Plain Washer
1.Frame
2.Insert fingers into the groove in the
front of frame and pull out to remove
the frame. (When reattaching the
frame, point the side with a groove
downwards and attach it.)
3.Lever
Insert the levers supplied with the
unit into the grooves at both sides of
the unit ad shown in figure until they
click. Pulling the levers makes possible
to remove the unit from the
dashboard.
Fastening the unit to the factory
radio mounting bracket:
1. Select a position where the screw
holes of the bracket and the
screw holes of the main unit
become aligned (are fitted), and
tighten the screws at 2 places on
each side. Use either truss screws
(5 x 5mm) or flush surface screws
(4 x 5mm)
2. Screw
3. Dashboard or Console
DIN REAR-MOUNT (Method B)
Installation using the screw holes
on the sides of the unit.
NOTE: The mounting box, outer
trim ring, and half-sleeve are not
used for method B installation.
INPUT THE SD CARD
The SD angle should be on top to
slide into this unit. Push it inside
the slot to make it work and then
press it again to have it eject.
