95
Once the test is complete, open the ControlSpace
TM
software and set the ESP-88 chassis so
that there is no connection, as shown in the examples below. This must be done so that the
chassis will not be configured for pass-through when it gets back to the customer.
Setting of outside of ESP
No connection
Write no connection by “connecting”. And disconnect.
Push ok button on ATS Basic Macro dialog.
Then return to first dialog, choose finish or continue.
TEST PROCEDURES
Summary of Contents for ControlSpace ESP-88
Page 97: ...97 Figure 8 Motherboard Top Etch Layout Diagram Figure 9 Motherboard VCC Etch Layout Diagram...
Page 101: ...101 Figure 16 DSP PCB Topside Etch Layout Diagram Figure 17 DSP PCB VCC Etch Layout Diagram...
Page 102: ...102 Figure 18 DSP PCB GND Etch Layout Diagram Figure 19 DSP PCB Bottom Etch Layout Diagram...
