17
DISASSEMBLY PROCEDURES
Disassembly
The following procedure shows the disassem-
bly of the bass module to allow access to the
DSP and I/O boards.
Note:
The cabinet is glued together prevent-
ing any type of internal repair beyond the
boards. The woofer and the transformer are
both inside the cabinet and cannot be re-
placed.
1. DSP board removal
1.1
Remove the four phillips-head screws
from the rear cover.
1.2
Pull the rear cover down and remove the
cables connected to J2, J21 and J22 on the
I/O board and J8000 from the DSP board.
1.3
Remove the four Phillips-head screws
located to the left and right of the heatsink.
1.4
Remove the cables connected to J350
and J10, this allows the heatsink and DSP
board to pull away from the bass module
cabinet.