15
G
ETTING
Y
OUR
H
EADSET
R
EADY
FOR
U
SE
CAUTION:
Do not attempt to pull the connector out without first pulling
back on the sleeve. Forcing the connector out will cause damage to the cable
and/or your aircraft instrument panel.
Figure 11
Attaching and removing the
cable
Slide sleeve
to release
Align keyway
Mounting the connector
Mount the connector into a cutout, as shown in Figure 12 below.
Connect the eight wires as follows:
• Two for the microphone
• Two for audio
• One for power
• One for ground
• Two for audio shields
Audio and microphone wires should be connected to the back of the
existing microphone and headphone jacks, leaving existing jacks
intact for use with conventional headsets. This is usually the fastest
installation method (see Figures 1 – 4 for reference). Audio shields
should be connected to ground at the existing jack.
(Caution: Use of two headsets wired in parallel is not advised. This
may result in reduced performance.)
Figure 12
Harness connector and
schematic
12.5mm
.49"
.55"
14.0mm
Pin 6
Pin 1
Backnut
Front Nut
M14 X 1
Hex Nut
RED
•
1 V+IN
BLK
•
2 GND
WHT
•
3 COMM L
BLU
•
4 COMM R
WHT
•
5 MIC HI
WH/BLU
•
6 MIC LO
BLK/WH
BLK/WH
Panel Hole
Required
Receptacle -
Pinout
(Front View)
Receptacle -
Backnut
(Side View)
Aircraft
Interface
Schematic
00_AM270261-01_HeadsetXII.book Page 15 Tuesday, August 11, 2009 2:27 PM
