17
G
ETTING
Y
OUR
H
EADSET
R
EADY
FOR
U
SE
Notes
• For use with a stereo intercom, connect the left and right channels
to their respective positions. If your intercom provides a monaural
audio signal, connect pins 3 & 4 together to the tip of the existing
phone jack.
• Do not use excessive force or bend the installed connector.
This may damage or break internal solder joints.
• If the boom microphone works on radio transmit but not through
the intercom, check pin 6. It may be incorrectly wired to the PTT
segment of the microphone jack.
• The wires connecting pins 3 & 4 and pins 5 & 6 are shielded,
twisted pairs with a shield termination exiting with a black/white
wire for each pair. Connect shields to existing audio wiring shields
or to audio ground, if existing wiring is not shielded.
• The Bose aircraft panel connector cannot be installed to an audio
system using transformer-coupled audio outputs. Call the Bose
Aviation Headset Department for details: 800-287-0611.
• Connecting power directly to pins 5 or 6 will result in damage to
the microphone.
• The wire guage is 22 AWG.
Adhesives approved for use with this connector are:
• VTCS-6 Vibratite
• Three Bond 1401
Do not let cyanoacrylate-based adhesives, flux remover, or other
caustic compounds contact the connector body. These chemicals
cause irreparable damage to the connector.
