Bose Sicilia Entero ESC, Installation Menu Manual

Page: 21 / 24

ENTERO ESC ‐ INSTALLATION MENU GUIDE
21
ABCD buttons:
These buttons are used to Enable/disable the panel (a combination of 3 of the 4 buttons is required to
enable the panel) and once the panel is enabled these buttons may have been configured for the
following functions (1 of below for each individual button):

Alarm zone(s) selection – when pre ‐ configured this way the button will select 1 or more
zones, or;

Message selection – when pre ‐ configured this way the button will select a different
message which can replace the default alarm message(s)
The ABCD buttons can have different functionality and different ‘enable codes’ for each emergency
panel used in the system; when required a single A, B, C or D button can also be completely disabled so
it has no function at all; all these possibilities can only be configured during setup of the system at
access level 3.
Activate Microphone or Pre ‐ recorded message(s) announcement:
The Entero emergency panels allow manual paging by use of a microphone (incl. pre ‐ announcement when
configured) or pre ‐ recorded messages. Up to 2 messages can be played at the same time, routed to different
alarm zones (not user configurable).
To activate the microphone or alarm message(s), perform the following steps:
1. Enable/disable emergency panel ‐ press the (pre ‐ configured) combination of 3 of the 4 A, B, C and D
buttons; when the code is right the Panel Disabled indicator will turn OFF.
2. Alarm zone selection ‐ alarm zones can be selected in different ways:
a. Press the ‘ALL ZONES’ button to select all alarm zones, or;
b. Press the ‘A, B, C or D’ button if these are pre ‐ configured with a group of alarm zones, or;
c. Press 1 or more zones on the 12 button expansion card
NOTE: the corresponding indicator will illuminate when a button is pressed; press the button
again to de ‐ select; all ‘Alarm zone’ buttons are pre ‐ configured.
3. Activate emergency ‐ to start the emergency:
d. Press and hold the ‘Microphone button’*; when pre ‐ configured a pre ‐ announcement will be
played; the red indicator will start to flash and when pre ‐ announcement is finished the
indicator will light up continuously; the microphone can now be used for speech, or;
e. Press the ‘Start/reset Alarm’ button; the pre ‐ configured message(s) will be played in the
selected alarm zones**
* NOTE: the hand ‐ held microphone on the Fire Panel has a ‘push to talk’ button which, if pressed,
directly routes the microphone signal to ALL zones.
** NOTE: when alarm messages are playing at any moment one can press and hold the ‘Microphone’
button to temporary take over the emergency; when the buttons is released again the alarm messages
will continue to play.
To STOP an emergency:
1. Microphone announcement ‐ release the button (or the Fire Panel hand ‐ held microphone button) to
stop the emergency announcement, or;
2. Pre ‐ recorded message(s) – press the ‘Start/reset Alarm’ button again to stop the emergency
message(s)