Boschetti Industrie Meccaniche srl
19
IT
Ver. 01/2019
Burner’s ignition
First of all open the gas shutoff cock uphill
Push the button (pic. 16 - pos. A) and turn it contemporaneously anticlockwise untill the position (spark) is reached.
Push the button (pic. 16 - pos. A) and start more than once the piezoelectric ignitor (pic. 16 - pos. B) untill the pilot
burner lights up.
Keep the button pushed (pic. 16 - pos. A) for 10-20 seconds, than let it and check if the burner has lighted up.
When the burner is alight, push the button again and turn it anticlockwise untill to the position corresponding with the
symbol “
I
”. On release, the button returns to the position (flame ).
Note: If the burner does not light up, repeat the operation again; a new attempt can carried out only after 2-3 minutes.
Temperature setting
Set the thermostat as you please (pic. 16 - pos. T). For this purpose consult the following scheme:
Note: For an economic working and a long endurance of the device, it is advisable to keep the thermostat on the
position 4.
Note: The temperatures indicated in the table are approximate. There may be margins on the indicated temperature of
± 7 °C.
Off burner
Turn the thermostat to position 1 (pic. 16 - pos. T). Push the button (pic. 16 - pos. A) and contemporaneously turn it
untill the position
(full disk) is reached. Close the gas shoutoff cock uphill.
Position
1
2
3
4
5
°C
40
45
55
60
70
Picture 16
Control panel
A - Button mode
B - Piezoelectric ignitor
T - Setting knob
A
B
T
