Bosch XQG100-WDU286H1AW, Manual

Page: 53 / 64

Troubleshooting
en
53
Fault Cause and troubleshooting
The spin programme
does not start.
Note:
Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶
Start the
单脱水
programme.
Loud noises during
the spin cycle. Appliance is not correctly aligned.
▶
Aligning the appliance
The appliance feet are not fixed.
▶
Secure the appliance feet. Aligning the appliance
Transit bolts have not been removed.
▶
Removing the transit bolts.
Banging noises, rat-
tling in the drain
pump. Foreign bodies have got into the drain pump.
▶
→ "Cleaning the drain pump", Page 43
Slurping, rhythmical
suction noise. The drain pump is active, the detergent solution is
pumped out.
▶
Not a fault – normal operating noise.
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp. A low spin speed is selected.
▶
The next time you run a wash cycle, set a higher
spin speed.
▶
Start the
单脱水
programme.
轻松熨
is activated.
▶
Select the programmes that are suitable for the
type of fabric.
Drain pipe or water outlet hose is blocked.
▶
Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
▶
Ensure that the drain pipe and water drain hose are
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
▶
Redistribute the laundry in the drum.
Note:
Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶
Start the
单脱水
programme.
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
▶
Redistribute the laundry in the drum.