Installation and connection
en
43
Alignment
1.
Loosen the lock nut in a clockwise
direction with a wrench.
2.
Check the alignment of the washer
dryer with a spirit level and, if
required, correct. Adjust the height
by rotating the appliance foot.
Note:
All four appliance feet must
be firmly on the floor.
The washer dryer must not wobble!
3.
Tighten the lock nut against the
housing.
Grip the foot and do not adjust the
height.
Notes
■
The lock nuts on all four appliance
feet must be screwed tightly against
the housing!
■
Any loud noises, intense vibrations
or “wandering” may be due to
incorrect alignment!
Electrical connection
Electrical safety
:
Warning
Risk of electric shock!
Risk of death if live parts are touched.
■
When disconnecting the main plug,
always pull the plug itself and not the
cable, otherwise the cable could be
damaged.
■
Never touch or hold the mains plug
with wet hands.
■
Never pull out the mains plug during
operation.
■
Only connect the washer dryer to an
alternating current using a correctly
installed earthed socket.
■
The mains voltage must be the same
as the voltage specifications on the
washer dryer (appliance rating
plate).
■
The connected load and the required
fuse are also indicated on the
appliance rating plate.
Ensure that:
■
The mains plug and socket match.
■
The cable cross-section is adequate.
■
The earthing system has been
installed correctly.
■
A damaged power cord is only
replaced by an electrician.
A replacement mains cable can be
obtained from customer service.
■
You do not use multiple plugs/
couplings or extension cables.
■
If a residual-current-operated circuit
breaker is used, you use only a type
which features this symbol:
z
.
Only this symbol guarantees
compliance with the currently valid
regulations.
■
The mains plug is always accessible.
■
The power cord is not kinked,
crushed, altered or severed and has
not come into contact with any heat
sources.
