en
Faults and what to do about them
42
Filter in the water inlet hose
blocked
:
Warning
Danger of death!
Do not immerse the Aqua-Stop safety
device in water (it contains an electric
valve).
First, reduce the water pressure in the
supply hose:
1.
Turn off the tap.
2.
Select any programme
(except
O
/
0
/
[
Rinse/Spin/Drain
).
3.
Select
A
Start/Reload
. Allow the
programme to run for approx. 40 s.
4.
Turn the programme selector to
Off
.
Pull out the mains plug.
5.
Clean the filter on the tap:
Disconnect the hose from the water
tap.
Clean the filter with a small brush.
6.
Clean the filter on the back of the
appliance:
Remove the hose from the rear of
the appliance.
Take out the filter with pliers and
clean it.
7.
Connect the hose and check for
leaks.
3
Faults and what to do
about them
Faults and what to do about them
Emergency release, e.g. if a
power failure occurs
e.g. in the event of a power cut
The programme will continue running
when the power supply has been
restored.
However, if the laundry has to be
removed, the washer dryer door can be
opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with detergent
solution and laundry.
If possible, leave it to cool down.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning.
Wait until the drum has stopped turning.
