Troubleshooting
en
43
Fault
Cause and troubleshooting
Water is leaking out at
the water outlet hose.
Water outlet hose is not connected correctly.
▶
Connect the water outlet hose correctly.
→
"Water outlet connection types", Page 14
Fluff on the laundry.
Fluff has accumulated in the drum.
▶
Run the
Drum Clean
programme without any
laundry or detergent.
Water inlet noise dur-
ing the drying phase.
Drying phase requires water.
1.
Not a fault.
2.
Make sure that the water tap also remains open
during the drying phase.
Drying programme
does not start.
Door is not closed.
1.
Close the door.
2.
Press
Start / Pause
to start the programme.
No drying programme is selected.
▶
Select a suitable drying programme.
→
The laundry is too
damp.
Unsuitable programme for the type of fabric.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The load is too large.
After the end of the programme, warm laundry feels
damper than it actually is.
1.
Remove the laundry from the drum as soon as the
drying programme has finished.
2.
Spread the items of laundry for cooling.
Unsuitable dryness level set.
Drying target not adjusted.
Load too small.
Moisture sensor dirty.
Water tap is closed during the drying phase.
▶
Make sure that the water tap also remains open
during the drying phase.
The ambient temperature is greater than 30 °C.
▶
Ensure that the ambient temperature is lower than
30 °C.
Insufficient air circulation at the appliance's installation
location.
▶
Ventilate the appliance's installation location.