Programme default settings
en
35
0
Programme default
settings
Programme default settings
You can change the default settings for
selected programmes. The settings can
be changed even while the selected
programme is running. The effects
depending on the progress of the
programme.
6
Θερμοκρ
. (Temp.°C)
Before and after the programme starts,
you can change the temperature
setting, depending on what stage the
programme is in, by adjusting the
desired temperature on the display.
The maximum temperature that can be
set depends on the programme that has
been selected.
0
Στύψιμο
(Spin Speed)
Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme by adjusting the desired
speed on the display.
setting
2
:
2
=”No spin”. The rinsing
water is drained but there is no final
spin. The laundry stays wet inside the
drum, e.g. for items that should not be
spun.
You can select “No spin” to prevent
creasing if the laundry will not be taken
out of the appliance immediately after
the programme has ended.
The maximum speed that can be set
depending on the model and the
programme that has been selected.
Λήξη
σε
/
Διάρκεια
(Finish in/
Time Dry)
Before starting the programme
, you
can preselect the programme end
("Finish in" time) in 0.5h (h = hour)
increments (between “minimum
selectable ending time” and 9.5h) or 1
hour increments (between 10h and
24h) up to a maximum of 24 hours.
To do this:
1.
Select a programme (except
‰
My Time
στέγνωμα
(My Time
Dry)
*
programme).
The programme duration is
displayed for the selected
programme, e.g.
2:30
(hours:minutes).
2.
Select the
Λήξη
σε
/
Διάρκεια
(Finish
in/ Time Dry)
button repeatedly until
the required number of hours is
displayed.
3.
Select the
Έναρξη
/
Προσθήκη
ρούχων
(Start/Reload)
button.
The programme starts.
The selected number of hours (e.g.
8h
) is shown in the display panel
and counts down until the
programme starts. The duration of
the programme is then displayed.
Note:
The length of the programme is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
additional programme settings may also
change the programme duration.
After starting the programme
(if a
“Finish in” time has been selected and
the programme has not yet started), you
can change the preselected number of
hours as follows:
1.
Select the
Έναρξη
/
Προσθήκη
ρούχων
(Start/Reload)
button.
2.
Select the
Λήξη
σε
/
Διάρκεια
(Finish
in/ Time Dry)
button repeatedly to
change the number of hours.
3.
Select the
Έναρξη
/
Προσθήκη
ρούχων
(Start/Reload)
button.
* Depending on the model
Summary of Contents for WNA14400GR
Page 55: ...6 ...
