NLSet up and connect
▶
Transport the device upright.
1.
Pull the hoses out of the holders.
installation site
Plinth
Requirements
The device with
confirm.
Floor with wooden
beams
Place the device
guess at a
resistant
wooden plate (thick-
too minimal
30mm) which
screwed to the
floor.
2.
Loosen and remove all bolts of the 4
transport locks with a SW13 open-
end wrench
†
kitchen
The device al-
borrow under a
continuous work
place sheet,
that fixed with the
adjacent
cabinet is connected
Pine tree. Required
niche width:
60 cm.
on a wall
no snakes
between wall and
clamping device
man.
3.
Remove the mains connection cable from
the holder.
4.4 Removing transport locks
The device is secured for transport
with transport locks at the rear of the
device.
Remark:Save the screws
n
igingen and the
v
h
a
ul
the transport security
zen for a later
14
