6
|
Thermal disinfection
Gaz 6000 W
8 716 473 217 (2014/07)
4.7
Displays
5
Thermal disinfection
Have thermal disinfection carried out by a contractor (also see the
installation instructions).
6
Energy saving tips
Economy mode
The appliance is designed in such a way that gas consumption and
environmental pollution is kept to a minimum and comfort is as high as
possible. The supply of gas to the burner is regulated in accordance with
the home's heat demand. If the heat demand is low, the appliance
continues to operate with a small flame. The contractor refers to this
process as continuous control. As a result of continuous control,
temperature fluctuations are kept low and heat is distributed evenly in
the rooms. This may mean that the appliance is in operation for a longer
period of time but actually consumes less gas than an appliance that is
constantly being switched on and off.
Inspection/Maintenance
To ensure that gas consumption and environmental impact (pollution,
etc.) remain as low as possible over an extended period of time, we
recommend that you take out an inspection/maintenance contract with
an authorised installer covering the annual inspection and servicing and
maintenance at other times as required.
Thermostatic valves
Fully open the thermostatic radiator valves in order to achieve the
required room temperature. You can only change the required room
temperature at the controller when the temperature is not reached after
an extended period of time.
Venting
Never leave windows slightly open for ventilation purposes. Otherwise,
heat will be constantly discharged from the room without significantly
improving the room's air. It is better to fully open windows briefly.
Close the thermostatic radiator valves while airing rooms.
Circulation pump
If there is a circulation pump for hot water, use a timer programme to
control its operation according to the specific requirements (e.g.
morning, afternoon, evening).
7
Troubleshooting
All safety, modulation and control components are monitored by the
Heatronic system.
If a fault occurs during operation, the display shows the
symbol and
possibly
, and a fault code (e.g.
EA
) flashes.
If
and
appear:
▶ Press and hold down OK until the
and
symbols are no longer
displayed.
The appliance will start up again and the flow temperature will be
displayed.
If only
appears:
▶ Switch the applian
▶ ce first off and then on again by means of the standby key.
The appliance will start up again and the flow temperature will be
displayed.
If a fault persists:
▶ Contact your approved installer or Customer Service for assistance,
providing details of the fault and the appliance.
Appliance details
If you need to call Customer Services, it is helpful if you have the precise
details of your appliance at hand.
Those details can be found on the identification plate or identification
sticker inside the control panel cover.
Gaz 6000 W (e.g.. WBN 6000-30-H-E-N/L-S2400).
...................................................................................................
Series number
...................................................................................................
Commissioning date:
...................................................................................................
System contractor:
...................................................................................................
Special
display
Description
Venting function enabled (approx. 2 minutes).
Summer mode (appliance frost protection)
e.g.
EA
Fault code (
chapter 7)
only
Standby
Table 3
An overview of the display indications can be found on
page 5.
Summary of Contents for WBN 6000-30-H-E-N/L-S2400
Page 8: ......
