Bosch WAY32890SN, Instruction Manual And Installation Instructions

Page: 51 / 76

51
Odour formation in
the washing ma-
chine. Run Cottons 90 °C programme without washing.
Use standard detergent.
Repeated, intensive
foaming. – Check basic dosage settings and dosage strength.
– If required, use a different liquid detergent.
Detergent/softener
drips off the seal and
collects on the door
or in the seal fold. Too much detergent/softener in the dispensers. Observe max
mark in the dispensers.
i-DOS
i
/
w
preset-
ting deleted.
If the
i-DOS
i
/
w
: content
menu setting is changed, all settings are
changed.
~
Page 37
Loud noise forma-
tion, vibrations and
“wandering” during
spin cycle. – Appliance aligned?
Align the appliance.
~
Page 65
– Appliance feet fixed?
Secure appliance feet.
~
Page 65
– Transportation safety devices removed?
Remove transportation protection devices.
~
Page 59
Display panel/indi-
cator lights do not
function while the
appliance is running. – Power failure?
– Fuse tripped? Switch on/replace fuse.
– If the fault occurs repeatedly, call customer service.
~
Page 52
The programme
takes longer than
usual. – Not a fault – unbalanced load detection system adjusts imbal-
ance by repeatedly distributing the washing.
– Not a fault – foam detection system active – several rinse cycles
are switched on.
Detergent residue
on the washing. – Occasionally phosphate-free detergents contain water-insoluble
residue.
– Select Rinsing or brush the laundry after washing.
In the pause status
A
(Start/Reload)
flashes very quickly
and a signal sounds.
– Water level too high. Washing cannot be reloaded. Immediately
close washing machine door.
– Select
A
(
Start
/Reload)
to continue the programme.
If a fault cannot be rectified (switching the machine on and off) or a repair is required:
– Switch off the appliance and pull out the mains plug.
– Turn off the tap and call customer service.
~
Page 52
Faults Cause/Remedy