en
Cleaning and servicing
54
Clean the water inlet filters.
Clean the filter in the water inlet in the
event of blockages or if the water pres-
sure is too low.
Emptying the water inlet hose
1.
Turn off the tap.
2.
Set a programme, except for
Rinse
,
Spin
or
Drain
.
3.
Start the programme and leave it to
run for approx. 40 seconds.
4.
Switch off the appliance.
5.
Disconnect the appliance's mains
plug from the power supply.
Cleaning the filter on the tap
Note:
Please read the safety informa-
to ensure that you use
the appliance safely.
Requirement:
The water inlet hose is
empty.
1.
Remove the water inlet hose from
the tap.
2.
Clean the filter with a small brush.
3.
Connect the water inlet hose and
check for leaks.
Cleaning the filter on the appliance
Note:
Please read the safety informa-
to ensure that you use
the appliance safely.
Requirement:
The water inlet hose is
empty.
Summary of Contents for WAX32GH1GB
Page 67: ......