Bosch WAW285H1UC, Use And Care Manual / Installation Instructions

Page: 25 / 48

25
Liquid detergent insert
To measure liquid detergent:
1.
Pull out the detergent dispenser tray.
2.
Push the liquid detergent insert forward and down as
shown.
3.
Pour liquid detergent into the chamber and do not
exceed the maximum mark.
4.
Reinsert the tray into its compartment.
NOTICE:
Do not use the liquid detergent insert with gel-
type detergents and powdered detergents or for cycles
with pre-wash or selected "Finish in" time.
Starting the program
Press the
Start/Pause
button. Indicator lamp lights up
and the program starts.
NOTICE:
If you want to protect the cycle against
inadvertent adjustment, select the Child lock 3 sec..
~
Child lock 3 sec.; Page 36
The display panel shows the "Finish in" time before the
program starts or the program length and the program
progress symbols when the washing program has
started.
~
Display area; Page 21
Foam detection
If you use too much detergent, too much foam may be
formed during the wash cycle. The symbol
Å
lights up.
Foam may be also leaking out from the detergent
drawer. In order to remove the foam, the appliance
automatically activates additional rinse cycles. This
extends program duration.
NOTICE:
To prevent excess foaming use less detergent
in subsequent wash loads.
Selecting a different program
If you have inadvertently started the wrong program, you
can change this as follows:
1.
Press
Start/Pause
.
2.
Select another program.
3.
Press
Start/Pause
. The new cycle starts from the
beginning.
Pausing/Adding a garment to the cycle
Pausing the wash cycle can be useful for several
purposes.
e.g. for soaking
~
Soaking; Page 34
Press
Start/Pause
. The indicator lamp
A
is blinking.
Wash load will soak in water until continued by pressing
Start/Pause
.
For adding a garment after the cycle begins.
1.
Press
Start/Pause
. Door will unlock when safe to do
so.
2.
Open door carefully and add or remove laundry item.
NOTICE:
You can do this as long as the
Start/Pause
indicator flashes and it is safe to do so.
3.
Close door.
4.
Press
Start/Pause
.
The cycle continues.
NOTICE:
If the cycle is paused but the door will not
unlock it could be for safety reasons (high water level,
water temperature or drum speed).
Cancel program
For cycles with a high temperature:
1.
Press
Start/Pause
.
2.
Cool the laundry off: Select
Rinse
.
3.
Press
Start/Pause
.
For cycles with a low temperature:
1.
Press
Start/Pause
.
2.
Select
Spin/Drain
and
Spin Speed
option to
No Spin
.
3.
Press
Start/Pause
.
Program end
- ‹ -
appears in the display field and the Start/Pause
button indicator lamp is off.
NOTICE:
If this symbol
Å
appears in the display, the
washer has detected too much foam and it automatically
adds an additional rinse cycles to remove the foam.
Use less detergent the next time you run the washer with
the similar load.