en
Troubleshooting
56
Fault
Cause and troubleshooting
"E:36 / -25 / -26"
Drain pump is blocked.
▶
"Cleaning the drain pump", Page 49
"E:38 / -25 / -26"
Drain pump is blocked.
▶
if the fault is displayed again,
▶
"Cleaning the drain pump", Page 49
Inlet opening of the rubber gasket is blocked.
▶
"Cleaning the intake opening in the rubber gas-
The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
▶
Clean the filters in the water inflow →
.
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked or jammed.
▶
Ensure that the water inlet hose is not kinked or
jammed.
Detergent dosage is too high.
▶
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
▶
Reduce the amount of detergent for the next wash-
ing cycle with the same load.
lights up.
The temperature is too high.
▶
Wait until the temperature has dropped.
▶
"Cancelling the programme", Page 39
Water level is too high.
▶
Start the
Drain
programme.
Laundry is caught in the door.
1.
Open the door again.
2.
Remove any trapped laundry.
3.
Close the door.
4.
Press
Start / Reload / Pause
to start the pro-
gramme.
Summary of Contents for WAV32M40TH
Page 54: ...en Cleaning and servicing 54 5 Connect the hose and check for leaks 2 1 ...
Page 69: ......
Page 70: ......
Page 71: ......