en
Faults and what to do about them
48
The wrong detergent/fab-
ric softener has been
poured into the dis-
penser(s).
Empty the dispenser(s), clean it/them and pour in the correct product.
"Emptying the i-DOS detergent drawer, cleaning the i-DOS detergent
drawer and its housing" on page 38
"Filling the dispensers:" on page 35
Detergent/fabric softener
has congealed in the dis-
pensers.
Empty the dispenser(s), clean it/them and pour in the correct product.
"Emptying the i-DOS detergent drawer, cleaning the i-DOS detergent
drawer and its housing" on page 38
"Filling the dispensers:" on page 35
Foam is leaking from the
detergent drawer.
■
Automatic dosing: Check the i-DOS dosage settings and, if required, reduce
the detergent dosage.
If necessary, use a different liquid detergent/fabric softener.
■
Manual dosing: Have you used too much detergent? Use less detergent for
the next wash cycle.
■
Immediate action: Mix one tablespoon of fabric softener with 1/2 litre of
water and pour it into the manual dosing compartment (not suitable for out-
door clothing, sportswear or items stuffed with down).
Repeated, intensive foam-
ing.
■
Automatic dosing: Check the i-DOS dosage settings and, if required, reduce
the detergent dosage.
If necessary, use a different liquid detergent/fabric softener.
■
Manual dosing: Have you used too much detergent? Add less detergent the
next time you run a wash cycle with the same load.
Detergent/fabric softener
drips off the seal and col-
lects on the door or in the
seal fold.
There is too much detergent/fabric softener in the dispensers. Do not fill the
dispensers above the
max.
mark.
The washing result is not
satisfactory.
■
Check the i-DOS dosage settings and, if required, increase the detergent
dosage.
■
Use a different liquid detergent.
The spin result is not sat-
isfactory.
Laundry wet/too damp.
■
Not a fault – the unbalanced load detection system has interrupted the spin
cycle because the laundry is unevenly distributed. Distribute small and
large items of laundry evenly in the drum.
■
Is
硄壌
(Easy iron)
selected? (depending on the model)
■
Is
㬮瞥
(Silent wash)
selected?
■
Is the selected speed too low?
The spin cycle runs sev-
eral times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
The programme is taking
longer than usual.
■
Not a fault – the unbalanced load detection system is adjusting an imbal-
ance by repeatedly distributing the laundry.
■
Not a fault – the foam detection system is active – a rinse cycle has been
switched on.
The length of the pro-
gramme changes during
the wash cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown on the Touch-
Display.
Faults
Cause/Remedy
Summary of Contents for WAU28640TC
Page 51: ...6 ...
