en
Operating the appliance
34
Child lock 3 sec./operation
lock
E
3 sec.
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently in the
control panel.
To
activate
/deactivate the
childproof
lock
, touch and hold the control panel
E
3 sec. for approx. three seconds. The
display switches to full brightness.
If you turn the programme selector or
touch the control panel while the
childproof lock is active, the
E
3 sec.
indicator flashes briefly and a signal
sounds. The programme runs through
to the end unchanged.
Notes
■
The childproof lock can be activated
regardless of the appliance's status.
■
The childproof lock remains active,
even once the washing machine has
been switched off.
■
If the appliance is switched off while
the programme is running and the
childproof lock has been activated,
the programme will resume when the
appliance is switched back on.
Adding laundry
After starting the programme, you can
add or remove laundry if necessary.
To do this, touch the control panel
A
.
The indicator flashes. The machine is
paused and checks whether a top-up is
possible.
If the display
è
goes out, a top-up is
possible. The door is then unlocked and
can be opened.
To continue the programme. touch
A
again. The programme continues
automatically.
Notes
■
Do not leave the door open for too
long when adding laundry as water
from the laundry may leak out.
■
For safety reasons, the door remains
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Follow the information on the display
panel.
■
The load display is not active during
reloading.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Touch the control panel
A
.
2.
Select another programme.
3.
And touch
A
again.The new
program starts from the beginning.
Cancel the programme
For programs at high temperature:
1.
Touch the control panel
A
.
2.
To cool the laundry: Select
Rinse
.
3.
And touch
A
again.
For programmes at low temperatures:
1.
Touch
A
.
2.
Select
Spin
or
Drain
.
3.
And touch
A
again.
Programme end during rinse
hold
The
A
indicator flashes in the display
panel, and the preset spin speed and
remaining programme length are
displayed for the selected programme.
Continue the programme by:
■
Touching
A
on the control panel or
■
Changing the spin speed and then
touching
A
or
