Bosch Security Systems | 2004-06
EN
| 10
7902 - 7905
| Installation and Operational Manual
8. Adjust settings of
walk test LED
and/or
pulse counter
, if
required.
See section
'PIR settings'
.
9. Fit the front cover. Check if it is locked to the bottom side.
10. Fasten the fixation-screw.
Remark:
The PIR detector will start detecting movement
approximately 2 minutes after mains power-on.
PIR settings
There are 2 jumpers to set the PIR to your own requirements:
•
Walk test LED
•
Pulse counter (1, 2 or 3)
See previous figure for the location of the jumpers.
Walk test LED
•
jumper installed:
Walk test LED is activated. When the PIR sensor is triggered, the
LED will light.
•
jumper not installed:
Walk test LED is deactivated.
Pulse counter
Set this jumper to select the number of times the sensor must be
triggered (1, 2 or 3 times) before an alarm is generated.
The following jumper settings are possible:
