Bosch VG5-7230-CPT5, Operation Manual

Page: 30 / 152

30 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts AUTODOME IP starlight 7000 HD
2016-07 | 1.0 | F.01U.283.679 Operation Manual Bosch Security Systems
6. Route the 24 VAC outgoing power supply wires into the VG4-PA0 power supply box
through the conduit fitting on the left side of the box.
7. Cut and trim the 24 VAC power and ground wires with sufficient slack to reach their
connector terminal in the box, but not so long as to be pinched by or to obstruct closing
the cover door.
8. Attach the supplied 3-pin power plug to the incoming 24 VAC power wires in the box, as
illustrated below.
GND TXD RXD C+ C- GND TXD RXD C+ C-
P101
1 2 3
6 5 4 3 2 1 6 5 4 5 4 3 2 1 6 5 4 5 4 5 4 6 5 4 5 4 6 5 4 5 4 5 4 6 5 4 6 5 4 6 5 4 3 2 1 3 2 1 6 5 4 3 2 5 4 3 2 3 2 5 4 3 2
P106 P105
P10
7
XF
10
2
XF
10
3
XF
10
1
5
4
3
2
1
J1
03
J1
03
J1
03
J102
J101
(LED)
HTR DOME
XD
(FUSE)
(FUSE)
(FUSE)
24V NC 24V
Figure 7.8: VG4-PA0 Power Supply Box
1 Incoming 24 VAC Power Supply Wires (from VG4-PSU1/VG4-PSU2 power supply box)
2 Ground Wire
3 P101 Connector
4 Control Data and Video In/Out Wires (analog models only)
9. Follow the instructions in Attach Pendant Arm to Power Supply Box, page 30 to continue the
installation.
7.4 Attach Pendant Arm to Power Supply Box
The bottom hinge pin of the Pendant Arm is provided with a Hinge Pin Stop to hold the hinge
open while attaching the arm to the Power Supply Box.
1.
Compress the bottom hinge pin by pushing the pin lever downward and rotating it behind
the Hinge Pin Stop.