Bosch UHI Series, Operation Manual

Page: 19 / 36

Connection - Most Models
Camera/Lens wiring
See Connection - UHO-HBPS-11, -51 | UHO-HPS-51, page 26 for UHO-HBPS-11, UHO-HPS-51,
and UHO-HBPS-51 models.
!
Warning!
Use only cables meeting specifications in Cable requirements, page 14 to wire cameras and
lenses.
Fittings
The 3/8-in. NPT fitting accepts a round cable with diameter from 4.0 mm (0.16 in.) to 7.0 mm
(0.28 in.).
The two larger 1/2-in. NPT fittings accept cables with diameters from 6.5 mm (0.26 in.) to
10.5 mm (0.42 in.).
Caution!
Always securely tighten all fittings to ensure a liquid-tight seal. Failure to do so could allow
water to enter the housing and to damage the camera and lens. If a sealant is used, ensure
that it is a neutral cure type. Sealants that release acetic acid may harm camera electronics.
Use of drip loops is recommended on the wiring outside of the rear end cap.
Conduit
These housings allow direct connection of conduit.
1.
Remove the rear hole plugs and attach the conduit and conduit fittings directly to the
housing rear cap. The holes accept either 3/8-in. NPT or 1/2-in. NPT conduit fittings.
2. Any unused holes must be covered using the plugs provided with the housing.
Feed-through Wiring
Use feed-through mounts to feed cabling through the foot of the housing.
1.
Prior to mounting the camera, remove the two dome plugs located inside the housing.
5
5.1
5.1.1
5.1.2
5.1.3
UHI/UHO Series Camera Housing Connection - Most Models | en 19
Bosch Security Systems, Inc. Operation Manual 2014.05 | 4.0 | F.01U.167.418