Bosch TWK 7901, Instruction Manual

Page: 6 / 42

4
Robert Bosch Hausgeräte GmbH
en
Congratulations on purchasing this
Bosch appliance. You have acquired a
high-quality product that will bring you
a lot of enjoyment.
Parts and operating
controls
1 Kettle (with water level indicator)
2
Lid with lock
3 Lid release button
4 ON/OFF
O
switch, illuminated
5 Limescale filter (removable)
6 Base
7
Cable tidy
Important: Use the kettle 1 only with its
included base 6 .
● Only fill the kettle with water. Milk and
instant beverages will burn and damage
the appliance. Never operate the kettle
1 without water and do not overfill it;
observe the min and max markings. If
the kettle is too full, the water will boil
over!
Before using
for the first time
● Remove any stickers or film.
● Unroll the right amount of cable from the
cable tidy
7
and plug it in.
● Fill the kettle 1 with water. Bring the water
to a boil and discard it. Repeat the proce-
dure. This will make sure that the kettle is
clean for normal use.
● When the water comes to a boil for the
first time, add a tablespoon of white
vinegar.
Boiling water
● Fill the kettle with fresh water through the
spout or the open lid 2 (press lid release
button 3 ).
● Read the quantity on the water level indi-
cator. Do not fill with less than 0.3 litres or
more than 1.7 litres of water!
● Close the lid 2 until it locks and place the
kettle 1 on the base 6 .
● Press down the switch
4
; the switch lights
up. The water is heated.
● The kettle switches off automatically once
the water has boiled.
The appliance can also be switched off
at any time by pulling up the ON/OFF
O
switch 4 .
Warning: If you remove the kettle 1 from
the base and replace it before the heating
process is over, the kettle will not continue
to heat the water.