12
en
Robert Bosch Hausgeräte GmbH
● The following items are dishwasher-safe:
drip tray for coffee outlet (8c), coffee
grounds container (8b), grate for coffee
outlet (8d), aroma cover (2) and measur-
ing spoon (18).
● Wipe out the inside of the appliance (tray
holders and drawer).
Important:
Drip tray for coffee outlet (8c)
and coffee grounds container (8b) should
be emptied and cleaned daily to prevent
mould from developing.
N.B.:
If the appliance is cold when switched
on with the power switch
O / I
(9) or if it
switches off automatically after coffee has
been dispensed, it rinses automatically. In
other words the system cleans itself.
Important:
If the appliance has not been
used for a prolonged period of time (e.g.
after a vacation), clean the entire appliance
thoroughly, including the milk system and
brewing unit.
Cleaning the milk system
If the milk system was not cleaned after
milk has been dispensed, after a certain
amount of time the message
Rinse milk
system!
will appear on the display.
Clean the milk system immediately after use!
To clean, leave the rotary selector (6d) in the
same position it was in when last used.
To pre-clean the milk system automatically:
1. Select
f
by turning the rotary knob (14).
2. Place a tall, empty container under the
outlet (6c).
3. Push the outlet as close as possible to
the container.
4. Place the end of the milk tube (6e) into
the container.
5. Press the
start
button (10).
6. Pull the milk frother (6) to open it.
The machine automatically releases water
into the container and vacuums it up again
via the milk tube (6e) to rinse the milk sys-
tem. The rinse procedure stops automati-
cally after about 1 minute.
7. Push the milk frother (6) in to close it.
8. Empty the container and clean the milk
tube (6e).
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher).
Dismantling the milk system for cleaning:
1. Detach outlet (6c) from steam valve (6a)
(
Fig. C
).
2. Clean the individual parts with a deter-
gent solution and a soft brush. If neces-
sary, soak in a warm detergent solution.
3. Rinse all parts with clear water and dry
them.
4. Reassemble all the parts and replace
fully in the appliance.
¡
Risk of scalding
Use this appliance only after the milk frother
(6) has been fully assembled and installed.
