32
Robert Bosch Hausgeräte GmbH
en
Troubleshooting
The following table provides solutions for problems and glitches
that may arise as you use your TASSIMO machine. If you do not
ind a solution for your speciic problem, or the problem persists
after troubleshooting please contact our customer service
department
!
Note:
If piercing unit is missing, it may be purchased from
TASSIMO careline 08 00 032 88 33 or at www.tassimo.com.
Problem
Possible cause
Solution
Appliance not working;
no symbols light up.
There is no power supply.
Check that the appliance is
properly plugged into the
power supply.
I can‘t read the LC-
display because it is in
the wrong language.
You may want to change the
language setting.
Please proceed as described
in the section “Controls and
displays”.
Machine brews but no
drink dispensed.
The water tank was removed
during the brewing process or
there is air in the system.
Replace the water tank in the
appropriate position in your
TASSIMO machine. Start a
cleaning process with the
Service T DISC.
The loat in the water tank is
stuck.
Clean the water tank and
ensure the loat can move.
O
Automatic mode
not working, appliance
remains in stand-by
mode.
No T DISC inserted.
Check if T DISC has been
inserted.
The barcode could not be
detected.
Clean the bar code reading
window and try again or
smooth the barcode on the
T DISC out with your thumb.
Use another T DISC.
If problems persist contact the
TASSIMO careline.
08 00 032 88 33.
O
Automatic mode
skipped, appliance
goes straight to
N
Manual mode.
The barcode could not be
detected.
Clean the bar code reading
window.
Use another T DISC.
You can still prepare the drink
by holding down the start /stop
button.
More Customer Service information is available online at www.tassimo.com
TAS 65_85 EU 090618.indd 32
19.06.2009 08:26:08
