Bosch SPE68U55UC, Operating Instructions Manual

Page: 18 / 52

16
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Press the [On/Off] button.
2
Press the [+] button until the display jumps to “ h:01 ”.
3
Press the [+] or [-] button until the displayed time corresponds with your requirements.
h:01 = 1 hour delay
h:24 = 24 hour delay
4
Press [Start/Resume] to activate delay start.
To cancel delay start:
1
Press the [+] or [-] button until “h:00” is indicated on the digital display.
2
Press and hold
[Start/Resume]
for 3 seconds to cancel the cycle. You may now start a new cycle.
NOTE: Your dishwasher is protected against unintentional operation. If the dishwasher door remains open for more
than 4 seconds after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] but-
ton again and close the dishwasher door.
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash cycle ends. Auto Power Off can be
adjusted from P:00 to P:02.
To change the setting:
1
Press the [On/Off] button.
2
Hold down the
“A”
button (see page 14) and press
[Start/Resume]
until the display indicates
“H:0x” (x can be any number).
3
Release both buttons.
4
Press the “A” button until the display indicates “P:0x” .
5
Press the “C” button until the display corresponds with your requirements.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
6
Press [Start/Resume] to save the setting.
InfoLight® (model dependent)
An LED illuminates the floor to indicate the unit is running. If the dishwasher is installed at eye-level,
the LED is not visible.
To change the setting:
1
Press the [On/Off] button.
2
Hold down the “ A ” button (see page 14) and press [Start/Resume] until the display indicates
“ H:00 ”.
3
Release both buttons.
4
Press the “ A ” button until the display shows “ 1:01 ”.
5
Press the “ C ” button to switch between “ 1:01 ” = ON and “ 1:00 ” = OFF and press [Start/Resume]
to save.
Aquastop® Leak Protection
Our AquaStop® system contains leaks through a precisely engineered tub and sensor system that works
with our solid molded base. If a leak has occurred, it shuts down operation and automatically pumps
out water to avoid contact with the floor. It works 24/7 and can turn itself on.