10
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Open the door (top controls only) and press the
[On/Off]
button.
2
Press the
[+]
button until the display jumps to “
h:01
”.
3
Press the
[+]
or
[-]
button until the displayed time corresponds with your requirements.
h:01
= 1 hour delay
h:24
= 24 hour delay
4
Press
[Start]
to activate delay start and close the door (top controls only).
To cancel delay start:
1
Press the
[+]
or
[-]
button until
“h:00”
is indicated on the digital display.
2
Press and hold
[Start]
for 3 seconds to cancel the cycle. You may now start a new cycle.
InfoLight® (model dependent - top controls only)
An LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the
LED is not visible.
To change the setting:
1
Open the door and press the
[On/Off]
button.
2
Hold down the “
A
” button (see page 4) and press
[Start]
until the display indicates “
H:00
”.
3
Release both buttons.
4
Press the “
A
” button until the display shows “
1:01
”.
5
Press the “
C
” button to switch between “
1:01
” = ON and “
1:00
” = OFF and press
[Start]
to save.
Cycle Completion Signal (model dependent - top controls only)
1
Open the door and press the
[On/Off]
button.
2
Hold down the “
A
” button (see page 4) and press
[Start]
until the display indicates “
H:00
”.
3
Release both buttons.
4
Press the “
A
” button until the display shows “
b:02
”.
5
Press the “
C
” button to increase or decrease the tone “
b:00
” = OFF and “
b:03
” = LOUDEST
6
Press
[Start]
to save setting and close the door.
Intensive Drying
The final rinse uses a higher temperature which improves the drying results. The running time may increase slightly.
To turn intensive drying on:
1
Open the door (top controls only) and press the
[On/Off]
button.
2
Hold down the “
A
” button (see page 4) and press
[Start]
until the display indicates “
H:00
”.
3
Release both buttons.
4
Press the “
A
” button until the display shows “
d:00
”.
5
Press the “
C
” button to turn intensive drying on or off. “
d:01
” = ON and “
d:00
” = OFF
6
Press
[Start]
to save setting and close the door (top controls only).
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash cycle ends. Auto Power Off can be
adjusted from P:00 to P:02.
To change the factory setting (P:01):
1
Open the door (top controls only) and press the
[On/Off]
button.
2
Hold down the
“A”
button and press
[Start]
until the display indicates
“H:00”
.
3
Release both buttons.
4
Press the
“A”
button until the display indicates
“P:01”
.
5
Press the
“C”
button until the display corresponds with your requirements.
P:00
= dishwasher does not turn off automatically
P:01
= dishwasher turns off automatically after 1 minute
P:02
= dishwasher turns off automatically after 120 minutes (2 hours)
6
Press
[Start]
to save the setting and close the door (top controls only).