9
Wash Cycle Information
The cycle times in this Use and Care Manual are based on normal soil loads and 120°F incoming water and
will vary based on your actual conditions.
Note: Only sanitizing cycles have been designed to meet the requirements of 6 for soil removal and sanitiza-
tion efficacy. There is no intention, either directly or indirectly, to imply that all cycles have passed sanitiza-
tion performance tests.
Operating the Dishwasher
Start the dishwasher
1
Open the door (top controls only) and press the
[On/Off]
button. The LED of the last selected cycle flashes.
2
Select a cycle and desired options.
3
Press
[Start]
and close the door (top controls only) to begin the cycle.
Cancel a cycle
1
Open the door just far enough to expose the control panel (top controls only). Be careful of hot water
that may splash out.
2
Press and hold the
[Start]
button for approximately 3 seconds until the display reads
“0:01”.
3
Close the door (top controls only). Wait about 1 minute while the dishwasher drains.
4
Open the door (top controls only) and press the
[On/Off]
button.
Interrupt a cycle
1
Open the door just far enough to expose the control panel. Be careful of hot water that may splash out
(top controls only).
2
Press the
[On/Off]
button to turn the unit off.
3
To resume the cycle, press the
[On/Off]
button and close the dishwasher door (top controls only).
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
To change the setting:
1
Open the door (top controls only) and press the
[On/Off]
button.
2
Hold down the “
A
” button (see page 4) and press
[Start]
until the display indicates “
H:00
”.
3
Release both buttons.
4
Press the “
A
” button until the display shows “
r:04
”.
5
Press the “
C
” button to select the desired setting.
“
r:00
” = dispenser is OFF
“
r:01
” = lowest setting
“
r:02
” = low setting
“
r:03
” = medium setting
“
r:04
” = medium/high setting
“
r:05
” = high setting
“
r:06
” = highest setting
6
Press
[Start]
to save the setting and close the door (top controls only).
Table 3 - Wash Cycle Information
Heavy
Auto
Normal
Rinse
cycle time
110-125 min
105-129 min
95-119 min
9 min
cycle time with Half Load option
110 min
95-105 min
90-99 min
--
cycle time with Sanitize option
125-145 min
120-140 min
115-130 min
--
water consumption
16.7-21.9 L
4.4-5.8 gal
11.1-20.0 L
2.9-5.3 gal
8.2-16.3 L
2.2-4.3 gal
4.0 L
1.0 gal
wash temperature
66-71°C
151-160°F
55-66°C
131-151°F
50-55°C
122-131°F
incoming
incoming
rinse temperature
72°C
162°F
70°C
158°F
65-69°C
149-156°F
incoming
incoming
