CC404
|
Operators Guide | 17.0
Event Memory Recall
14
Bosch Security Systems | 7/05 | F01U009494B
17.0 Event Memory Recall
Use this function to replay the last 40 system events
that occurred. The event memory history replays all
alarms, and arming and disarming of the system in
AWAY Mode, STAY Mode 1, and STAY Mode 2.
The system cannot differentiate between
arming the system in STAY Mode 1 or
STAY Mode 2.
To enter Event Memory:
Enter your four-character Master Code and press
[8 #] (for example, [2 5 8 0 8 #]).
Three beeps sound. The last 40 events appear one at
a time by the codepad indicators, starting from the
most recent event. A beep sounds as each event
appears.
18.0 Day Alarm
Day alarm allows the system to monitor a
combination of zones when the system is disarmed
by beeping the codepad buzzer. Only your installer
can program Zones 1 to 4 to operate for day alarm.
Example
You can set up a day alarm at the front door of a
shop with a pressure mat or electronic beam that
customers activate as they enter and exit the shop. As
the customers walk onto the pressure mat or break
the electronic beam, the codepad buzzer beeps.
To turn day alarm on:
Hold down [4] until three beeps sound.
Day alarm turns on. If a zone programmed for day
alarm operation is activated when the system is
disarmed, the codepad beeps.
To turn day alarm off
Hold down [4] until two beeps sound.
Day alarm turns off.
19.0 Remote Arming By
Telephone
Use this feature to arm your system by telephone
from any remote location. For security reasons, you
cannot disarm the system using this method. This
feature requires a touch-tone telephone. Remote
arming works only if your installer programmed this
feature.
To arm your system remotely by telephone:
1. Call the telephone number connected to your
control panel.
When the control panel answers the incoming
call, a short jingle sounds.
2. To arm the system, press [*] on the touch-tone
telephone for 1 to 3 sec.
If you hear modem tones when the control panel
answers the incoming call, the system is
programmed for remote programming functions
by your installer. Wait for a pause between the
tones before you press [*].
After you release [*] on the touch-tone telephone,
two beeps sound. The system is armed in AWAY
Mode.
3. Hang up the telephone.
The system remains armed.
If your installer programmed answering
machine bypass, you must call the control
panel twice to connect to the system. For
example, call the telephone number for the
control panel, let the call ring no more
than four times, and then hang up the
telephone. Wait at least 8 sec and call the
control panel again.
